Big Savings On A Water Heater. How a properly sized, energy-efficient water heater pays for itself in lower bills and longer service life.
Read the transcript ▼
We're here in St. Petersburg. We're doing our water heater challenge. The challenge is we're going to cut this heater open and we're going to look inside and look at the sediment. We're going to give $100 off for every cup of sediment we pull out of this heater up to a maximum amount of $500. Here in the Tampa Bay area, we have very hard water. It's mostly calcium. That calcium builds up in the bottom of your heater and will ruin the heater over time. So, we are going to open it up. look inside, count everything that's in there, the cups of sediment, and then we'll take you through the rest of the process. >> All right, we've cut the heater open. This is our water heater challenge. We're going to see how many scoops of sediment we have in this water heater. Um, you ready to look inside it? I am. All right, here we go. Wow. >> Wow. >> There is a lot pouring out right there, too. >> I'm saving some money today. >> We've already got When we opened up the heater, we drained out. We've already got two cups of sediment right there. So, I'm going to start with two. >> Sure. >> All right. So there's three, four, five. So if I was a vetting man, I'd say there was eight or nine cups of sediment for sure in this heater. >> I agree. >> So the things are is yearly flushes on the heater and like a sediment filter or even a softener system for the house. So, we're going to be putting in a new heater here and we're going to put in a a water uh uh filtration system for you. >> Sounds good. >> All right. Thank you, sir. >> Thank you. >> For more information, go to titanplumbinglectric.com.
Big Savings On A Water Heater — Tampa Water Heater Walkthrough
How a properly sized, energy-efficient water heater pays for itself in lower bills and longer service life.
Tampa Bay water sits at 7–10 grains-per-gallon hardness, which is the main reason residential water heaters here fail at year 10–12 instead of the 15-year industry average. Sediment buries the lower element, the anode rod corrodes early, and the tank's bottom rusts from the inside. The video above shows what we see on a typical service call — and what we recommend doing about it.
In this clip: We're here in St.
Why Tampa Bay water destroys tanks faster
Hard water is the single biggest factor shortening water-heater life in Hillsborough, Pinellas, and Pasco counties. The minerals settle out as the water heats, building a layer at the bottom of the tank that insulates the lower heating element from the water it's supposed to warm. The element runs longer to compensate, the bottom of the tank scales over, and efficiency drops noticeably year over year.
By the time most homeowners notice ('the hot water doesn't last like it used to'), the tank usually has 1–3 inches of sediment, a rusted lower element, and an anode rod that's been gone for years. That's not a repair situation, that's an end-of-life signal.
How Titan replaces a water heater the right way
We size the new unit on actual demand, not just gallon count — fixture units, simultaneous draws, recovery rate. We pull the Hillsborough County (or local-jurisdiction) permit so the install is inspected and warranty-registered. We replace the supply lines, install a proper drip pan with a routed drain, and confirm the T&P discharge runs to a safe location.
If the failed unit was electric and your panel has spare capacity, the swap is usually a same-day job. If you're upgrading from tank to tankless, we evaluate panel capacity, gas line sizing, and venting before we quote so you're not surprised on install day.
- Proper sizing:fixture units, simultaneous draws, recovery rate
- Permit pulled, installation inspected by the county
- New supply lines, drip pan, routed drain
- T&P discharge routed to a code-compliant termination
- Manufacturer warranty registered in your name
Key takeaways
What this video covers in plain English
If your tank is past year eight and has never been flushed, the video above is what's happening inside it right now. These are the practical takeaways — what to do before the tank fails, and what changes when it does.
- Tampa hard water leaves 1–3 inches of sediment inside an unflushed tank by year ten
- Annual flushing typically extends tank life by 3–5 years
- Replacement sizing is about fixture demand, not gallon count alone
- Permitted, inspected installs are how the manufacturer warranty stays valid
Tampa Bay · Same-day service
Have a job like the one in the video?
Real Titan technicians, never sub-contracted. Flat-rate pricing quoted before any work begins. A+ BBB rated, family-owned since 1994.
More water heaters videos
Upgrade Your Water Heater And Save Big
Tampa hard water builds inches of sediment inside a typical residential water heater. Watch the Titan crew cut one open on a real Tampa job, count the scoops of sediment pulled out, take $100 off the new install for every cup (up to $500 off), and recommend the right filter system so it doesn't happen again.
Cutting Open A 40 Gal Water Heater
See what the inside of a 40-gallon water heater really looks like after years of Tampa hard water. Sediment, scale, and corrosion that quietly destroy efficiency.
How You Can Save $500 On Your Water Heater
Quick promo from Titan Plumbing & Electric: if your water heater is 6+ years old you may have up to 12 inches of sediment inside the tank. The first 50 callers get $100 off the new install for every cup of sediment we scoop out. Up to a $500 maximum discount.
